PM 9604 GPIB interface (Counters)
PM 6666 Full GPIB programmability, Auto trigger, voltage measurements.
Special bus functions
- Output separator selection
- High-speed dump
- MTCXO on/off
- Short output format
- Free run/Triggered measurements
- Set SRQ-mask
- Program data out queries
- Device identify query
General Specifications |
Programming code format |
|
7-bit ISO code (ASCII) characters. Upper or lower case characters. |
|
Input separator |
|
The counter accepts the following separators: ETX, ETB, CR, LF, " "(space), "," (comma), ":" (colon) ";" (semicolon) |
|
Output data separator |
|
Default separator at power-on is LF. The separator can be programmed to any non-printable ASCII-code with decimal equivalent 0-31, except 27 (ESC). The combination 13 + 10 (CR + LF) can be programmed. The EOI line can be programmed to be active together with the last output byte sent. |
|
Output format |
Normal: |
20 characters plus separators(s) 7 characters alphabetic header plus 13 characters numeric value |
Short output: |
Alphabetic header and leading zeroes are omitted. |
|
High-speed dump |
|
The contents of internal registers are transferred to the controller, without being processed by the counter. The processing must be done in the controller instead. |
Max output rate: |
approx 100 readings/s |
Output format: |
A 2 character header, followed by 12 Hex-digits plus separator(s) |
|
Max data output rate |
Normal mode: |
Approx 5 readings/s |
High-speed dump: |
Approx 100 readings/s |
|
Output time for measuring data |
Normal mode: |
Approx 15 rms (20 bytes) |
High speed mode: |
Approx 6 ms (15 bytes) |
|
Response time for addressing |
|
Response time for trigger command (GET) |
|
Typical read time for programming data |
|
|